Ariens SNO-THRO 932 Bedienungsanleitung PDF herunterladen (Seite 15)

Lubrication and Maintenance (Continued)

Friction Wheel

To replace friction wheel, tip unit up on housing on a

flat level surface.

Remove bottom cover by loosening two cap screws

at front on frame sides and removing two cap screws

at rear of frame.

Remove bearing flange on right hand side of frame,

and hairpin from traction clutch rod. Pull rod from

clutch fork arm and tip up and out of way.

Slide friction wheel assembly and hex shaft to right

until left end of hex shaft comes free of left bearing.

Slip assembly back to left and pull forward out of

frame.

Remove three cap screws securing friction wheel to

hub and remove friction wheel.

Secure new friction wheel onto hub with three cap

screws and torque cap screws to 8-10 foot pounds.

Reassemble in reverse order.

NOTE: Position friction wheel hub in forks. Be sure

washers are in place on bearing flange pins. Slide

hex shaft to left and into left bearing with flat washers

in position. Pinion gear must mesh with large gear.

Adjust traction drive clutch per instructions in

Adjustment Section.

Auger Gear Case

Check auger gear case lubricant level every 25 hours

of operation. Fill with Ariens Special L2 Gear Lube

(Part No. 000080).

To check, place unit in a warm location overnight to

allow lubricant to flow to level. RenfX}ve filler plug. Tip

unit forward until axle is 12 inches off smooth level

surface. Lubricant must be at least up to bottom of fill

hole with unit resting on 12 inch blocks under axle

(extra lubricant will not damage gear case).

1. Auger Gear Case

2. Grease Fill

3. Ariens Special L-2 Gear Lube

Figure 11: Auger Gear Case

1. Friction Wheel

2. Cap Screw

3. Bearing Flange Screws

Figure 10: Friction Wheei

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Ariens SNO-THRO 932 Bedienungsanleitung Seite 15