Ariens 926057 Spezifikationen PDF herunterladen (Seite 20)

EN - 20

RECOIL GUARD FOAM COVER

INSTALLATION

(Figure 9)

The recoil foam cover slides over the starter

handle and attaches to the recoil guard with

Velcro®.

NOTE: The recoil guard foam cover is not

necessary for operation during the non-winter

months.

IMPORTANT: When using the unit in the

winter months the cover must be installed.

The foam prevents snow from getting into the

recoil guard and freezing the recoil pawls.

IMPORTANT: Be sure to keep the recoil foam

cover clean and clear of snow and debris at

all times. See Clean Recoil Guard Foam

Cover on page 18.

SPEED SELECTOR

ADJUSTMENT

(Figure 8)

To adjust:

1. Disconnect adjustment pivot pin from

speed selector lever.

2. Place the speed selector in the fastest

forward speed position.

3. Turn the speed selector lever straight

down towards the ground as far as it will

go.

4. Thread the adjustment pivot pin along

the shift rod until it aligns with the mating

hole on the speed selector lever. Insert

the pivot pin into hole.

5. Secure adjustment pivot pin with hairpin.

6. Make sure the speed selector shifts into

each speed position.

7. Check forward and reverse speeds:

a. Start unit.

b. Shift speed selector into the first

forward speed.

c. Engage the traction clutch. Unit

should move forward.

d. Stop unit.

e. Shift speed selector into first

reverse speed.

f. Engage the traction clutch. Unit

should move backward.

g. Shut off unit.

8. Adjust pivot pin on the shift rod as

necessary so unit travels forward when

speed selector is in first forward position

and travels backward when speed

selector is in first reverse position.

9. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY.

Read and understand the entire

Safety section before

proceeding.

Figure 9

2

1

3

1. Recoil Guard Foam Cover

2. Velcro

®

3. Recoil Guard

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare