Ariens Platinum 30 Spezifikationen PDF herunterladen (Seite 30)

EN - 30

Check Attachment Idler Arm Roller

Clearance

(Figure 35)

1. Place the unit into the service position.

Remove the bottom cover.

2. With the attachment clutch lever

engaged, check the clearance between

the frame and plastic roller on the lower

end of the attachment idler arm.

• If roller is 1/2 – 7/8" (12.7 – 22.2 mm)

from frame, no further adjustment is

needed.

• If roller is more than 7/8" (22.2 mm)

from frame, loosen idler adjustment

nut and move idler away from the belt,

tighten adjustment nut and recheck

roller clearance.

• If roller is less than 1/2" (12.7 mm)

from frame, loosen idler adjustment

nut and move idler closer to the belt,

tighten adjustment nut and recheck

roller clearance.

Check Attachment Brake

(Figure 36)

1. With the attachment clutch lever

disengaged, brake pad must contact

attachment belts. With clutch lever

engaged, brake pad must be more than

1/16" (1.6 mm) from belts. If there is

more than 1/16" (1.6 mm) gap, go to

Check Belt Finger Clearance on

page 31. If there is less than 1/16" (1.6

mm) gap, go to step 2.

2. If there is less than 1/16" (1.6 mm) gap

between brake pad and belts, loosen

idler adjustment nut and move idler

away from belt. Position idler to achieve

a 1/16" (1.6 mm) minimum brake pad

gap and a 1/2 – 7/8" (12.7 – 22.2 mm)

gap between the plastic roller and the

frame.

IMPORTANT: If adjustments cannot be

brought into specified ranges see your Dealer

for repairs.

Figure 34

With the attachment clutch disengaged,

check the attachment idler arm position

here. The attachment idler arm should

lightly touch the frame.

Figure 35

OS7189

Roller should be 1/2 – 7/8"

(12.7 – 22.2 mm) from the frame when

the attachment clutch is engaged.

Figure 36

Minimum of 1/16" (1.6 mm)

1. Attachment Drive Belt

2. Brake Arm and Pad

3. Attachment Pulley

1

2

3

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare